For safety use ADJUSTABLE WRENCH / PLIERSturn anti-clockwisedirectionV・CV・VVRsingle coreCV・VVR3-corefig.5fig.6fig.7fig.3fig.4fig.8fig.9fig.10fig.2fig.1For safety use, please read the following attentions carefully before using tools.WARNINGCAUTION● The plastic handle is not insulated. Do not cut the energized wire.(pliers, combination pliers, diagonal cutting pliers and cutters)● Use safety goggles to protect eyes from scattering chips when cutting steel,copper and other wires. (pliers, lineman's pliers, diagonal cutting pliers and cutters)● Please use tools in original purposes. ● Turn adjustable wrench in the direction of lower jaw. If wrench is turned in the opposite direction, lower jaw may receive excessive force and break down. (fig.1)● The gap between bolt/nut and adjustable wrench makes wrench slip. Worn out bolt/nut let wrench slip too, please be careful. (fig.2)● Adjustable wrench slips when using at slant angle against bolt/nut. (fig.3)● Please do not insert extension pipe into the handle of the adjustable wrench, the large force may break the wrench. (fig.4)● Please do not hit the grip by hammer.● If combination pliers is used to turn bolt / nut of larger size,top of jaws will open and cannot grip parallel. (fig.6)● Adjust position of fixing screw to make handle opened adequately. (fig.7)● Beware not to pinch hand / finger. Hold the center of grip.(pliers, lineman's pliers, diagonal cutting pliers and cutters)● Do not bend needle nose pliers as nose is made long and thin.● Read instruction manual carefully before using ratchet cable cutter. (fig.8)● Cutting capacity of ratchet cable cutter : IV, CV, DV, VVR soft copper wire 600v (fig.9)● For both ratchet cable and handy cable cutter can not cut hard copper wire. (aluminum conductor steel-reinforced cable(ACSR), steel wire and piano wire)● Do not apply excessive force when turning, twisting or pushing aside the cutter.Wrong use might damage cutting blade of trap cutter or tube cutter.● When using trap cutter or tube cutter, store round-cutter blade beforehand to protect fingers from injury. (fig.10)● Handle carefully when using trap cutter or tube cutter.● For both trap cutter and tube cutter, please be careful when cutting and replacing blades.384
元のページ ../index.html#386